| 1 comments ]

These shots are from Michael Massaia's Afterlife, which capture the final days of Jersey Shore amusement parks.


On his process:

Well, first, it all starts with capturing the image. I will usually spend a few days walking around the area prior to taking the images. I try to find areas I can sneak into where I won’t be noticed. I still only use large format black & white film because of its superior resolution and dynamic range (especially in highlights). I try to capture most of my images on days when there is little to no wind. I also prefer days that are overcast, so I can get more of an even tonality throughout the entire negative.

I never composite or combine multiple images. Every image is created using one shot/piece of film.

After the image is captured, I develop the negative so it’s fairly low contrast, so I keep that even tonality intact. I then have to create an enlarged negative from the original negative because a platinum print can only be made through a contact printing process.

No enlargers can be used, so your negative must be the size of your final print.

After I create a decent enlarged negative, I then start to work on the paper in which the print will be made on. Finding a good 100 percent rag paper to make a platinum print on can be tough because of the different acidity levels, and different sizing that varies from paper to paper.

After you’ve found a good batch of paper, you then have to mix your chemistry, which you will eventually have to hand-coat onto the paper using either a high quality paint brush or coating rod.

After I coat my paper (I do multiple coatings), the paper is forced dried using a print dryer and the enlarged negative is placed onto the platinum/palladium coated paper and then placed in a device called a vacuum frame which firmly presses the negative and paper together.

The print is then exposed, using a multi-spectrum metal halide lamp. Exposure usually takes 3-5 minutes. I do a large amount of “light dodging and burning” which is a common printmaking technique that allows you to selectively control the lighting throughout the entire print.

Some of this is done on the actual negative, and some is done while the print is being exposed. After the print is finished being exposed, it is developed in different developers, depending on the look you’re going for. After the print is developed, it then has to soak in a series of acid baths (hypo-clearing agent, citric acid, etc.) to remove the excess metal.

Finally, the print is washed for about an hour’.

1 comments

chelsea jade said... @ March 22, 2010 at 3:50 PM

i keep forgetting to facebook you back!
may we move our correspondence to the wonderful world of gmail?

chelsea.jade@gmail.com

Post a Comment